Skip to main content
🩹 Healing & Recovery Last updated 2026-07-20

ARA-290 16mg Dosage & Mixing Guide

Also known as: ARA290 · Cibinetide · Cibinetida · Cibinetid · Helix-B surface peptide · HBSP · pHBSP · nerve repair peptide · IRR agonist

Other sizes: 10mg

Trusted Supplier

Source from verified suppliers providing third-party testing and certificates of analysis (COA) for each batch.

View Trusted Supplier

Affiliate link — we may earn a commission at no extra cost to you

TL;DR

ARA-290 (cibinetide) is an 11-amino-acid peptide derived from the helix-B region of erythropoietin, studied in nerve-repair and small-fiber neuropathy research. It reached randomized, placebo-controlled Phase 2 human trials in sarcoidosis and diabetic neuropathy, though the studies were small and development did not continue. It is a research compound for laboratory investigation and educational reference only, not therapeutic use.

What is ARA-290?

ARA-290 (cibinetide) is an 11-amino-acid peptide derived from the Helix-B region of erythropoietin. Unlike EPO, it is non-erythropoietic (it does not raise red-cell counts) and acts on the innate repair receptor (IRR). It is studied for small-fibre neuropathy and nerve repair, and holds EU Orphan Drug Designation for sarcoidosis-associated neuropathy.

Reconstitution

ARA-290 reconstitutes with bacteriostatic water. Draw 2mL down the inside wall of the vial, swirl gently until fully dissolved, and refrigerate. Do not shake.

Quick Reference

ParameterValue
Peptide Amount16mg
Reconstitution SolventBacteriostatic water
Recommended Volume2mL
Resulting Concentration8mg/mL
Typical Research Dose1-4mg
Frequencydaily

Reconstitution Guide

Materials Needed

  • ARA-290 16mg lyophilized vial
  • Bacteriostatic water (BAC water)
  • Insulin syringes (U-100, 29-31 gauge)
  • Alcohol swabs
  • Sharps container

Step-by-Step Instructions

  1. Prepare workspace — Clean environment, gather materials, thorough handwashing.
  2. Clean vial stoppers — Wipe both vials with alcohol swabs. Allow complete drying.
  3. Draw BAC water — Draw 2mL bacteriostatic water using a sterile syringe.
  4. Add to peptide — Inject slowly down the inside wall of the vial. Do not spray directly onto the powder.
  5. Dissolve — Allow a few minutes for complete dissolution. Gentle swirl only — no shaking.
  6. Verify — Solution should be clear.
  7. Label and store — Note reconstitution date. Refrigerate immediately.

Dosage Protocol

Concentration Calculations

With 16mg peptide in 2mL BAC water:

  • Concentration: 8mg/mL (8000mcg/mL)
  • Per unit (U-100 syringe): 80mcg per unit

Run your exact vial and water combination through the peptide reconstitution calculator to rebuild this table for your setup.

Common Dose Calculations

Desired DoseDraw VolumeSyringe Units
1mg0.13mL13 units
2mg0.25mL25 units
4mg0.50mL50 units

Research Considerations

Mechanism

ARA-290 engages the innate repair receptor, a heteromer of the EPO receptor and the beta-common receptor, triggering tissue-protective and anti-inflammatory signalling without erythropoiesis.

Sourcing for Research

Source from verified suppliers that provide third-party testing and certificates of analysis (COA) for each batch. Compare purity documentation, shipping conditions, and batch traceability before purchasing research materials.

Storage Requirements

Lyophilized (Powder)

  • Temperature: -20°C or colder
  • Duration: 2+ years
  • Conditions: Dry, dark, protected from moisture

Reconstituted

  • Temperature: 2-8°C (refrigerated)
  • Duration: 2-3 weeks
  • Conditions: Protected from light, never freeze

Safety Considerations

  • ARA-290 is a research compound
  • Not approved for any indication in any jurisdiction
  • Research use only — not for human consumption
  • Use sterile technique; never reuse needles or syringes

Scientific References

  1. Research literature on ARA-290 and its proposed mechanism of action.
  2. Peer-reviewed and preclinical sources on the compound class discussed above.

Last updated: 2026-07-20.

Disclaimer: This information is for educational and research purposes only. ARA-290 is a research compound and is not approved for any use. Research-grade peptides are not intended for human consumption. Always follow applicable laws and institutional guidelines.

Research Use Only

ARA-290 is a research peptide not intended for human consumption.

Frequently Asked Questions

How do I reconstitute ARA-290 16mg?
Add 2mL BAC water of bacteriostatic water. Inject slowly down the side wall. Gently swirl until dissolved — never shake.
What is the typical dosage for ARA-290?
Typical research dosage: 1-4mg. Frequency: daily.
How should I store ARA-290?
Lyophilized: -20°C (2+ years). Reconstituted: 2-8°C (2-3 weeks). Protect from light.
What concentration does ARA-290 16mg make?
With 2mL BAC water BAC water: 8mg/mL. Use our calculator for exact volumes.